Complete electronic ignition kit containing alternator mounted ignition pickup, fittings and amplifier unit. Works with 12 volt 3 Ohm coils ELA14500 (big twins) and can be used to replace Digiplex on models with Ducati charging systems where the bike is converted to carburettors. This kit is just an ignition system, it will not control fuelling. The pickups for this kit are mounted on the alternator stator. Supplied with instructions in German with wiring diagrams.

2 year warranty on Sachse ignition kits

Once fitted no further adjustment should be necessary. Preloaded with nine ignition curves, two of which are designed for twin plugged bikes. See this link for fitting instructions. Some bikes may need at least one additional spacer to allow enough clearance for alternator cover to fit once pickup is fitted. Note that if you are replacing a Digiplex system you will also need to replace your 'square' coils with higher impedance 12 volt coils e.g. ELA14500

 This part is available by special order, request a quote

TPS for throttle body

On Cali 1100 check which TPS you have (varies according to ECU)

 This part is available by special order, request a quote

 01530500 GU01530500 01 53 05 00
 0153 0500 0153.0500 01.53.05.00

Prolong battery life with this 9 stage smart battery charger, suitable for 6v, 12v AGM and lead acid batteries.

Weatherproof - suitable for use outside 6V / 12V 1A Auto-sensing charger. Suits all AGM, Lead Acid, Calcium and Gel batteries Charges 6v and 12v batteries Ring terminal and alligator clip harnesses included Spark proof Maintains full charge Simple, connect and wait for green light Overload / Short circuit protection See ACA96001 for a spare set of charging leads (e.g. for a separate bike).

 This part is due back in stock soon, call 01484 841395 to reserve yours

Key blank for Zadi keys - check key profile before ordering

Key blank with plastic head for models without immobiliser chips

 This part is due back in stock soon, call 01484 841395 to reserve yours

Complete ignition switch with lock number, keys and steering lock plate

4 pin superseal connector included, Zadi switch has 4 positions

 Sorry, this part is no longer available.

 01782500 GU01782500 01 78 25 00
 0178 2500 0178.2500 01.78.25.00

Red NGK spark plug resistor cap with rubbers

Also known as suppressor cap

 Sorry, this part is no longer available.

LD05F

Marelli air temperature sensor

Supplied with screws. Superceded by ELA30330

 Sorry, this part is no longer available.

 30729331 GU30729331 30 72 93 31
 3072 9331 3072.9331 30.72.93.31

Fuel level sender for fuel tank

 Sorry, this part is no longer available.

01103030

Replacement regulator rectifier for models fitted with the Ducati charging system. This is a quality unit and is supplied with fitting instructions

Connections: 2 x yellow male bullet, 1 x white female bullet, 1 x black ring, 1 x red ring. You will need to reuse your existing block connectors to connect this to your loom. See this wiring diagram for wiring connections

 This part is due back in stock soon, call 01484 841395 to reserve yours

37703805-z 37703805 GU37703805 37 70 38 05
 3770 3805 3770.3805 37.70.38.05

Fuel level sender for fuel tank

2 pin connector block

 This part is available by special order, request a quote

 30103000 GU30103000 30 10 30 00
 3010 3000 3010.3000 30.10.30.00